PicoBNC+ Current Clamp 60A AC/DC
This current clamp in a new design with a high resolution and with the new PicoBNC+ connection technology is powered by the oscilloscope and therefore does not require a battery. The 60A current clamp is automatically recognized by the PicoScope software when it is connected to the oscilloscope and is automatically set in the PicoScope Software without the need to manually switch the measuring ranges.
The current probe is automatically calibrated by the software when it is connected to the oscilloscope, eliminating the need for manual zeroing.
Technical data:Measuring range: ±60A DC or AC peak
Resolution: ±1mA with improvement of the resolution
±10mA without improvement
Accuracy: 2% + 10mA (1% from the oscilloscope)
Current overload capacity: 100A DC (for 1 minute)
Maximum voltage: 150V CAT II
Bandwidth: 20kHz
Temperature coefficient: ±0.15% of reading / °C
Operation temperature range: 0 to +50°C
Storage temperatue rane: -20 to +85°C
Operation air humidity range: 15% to 85% RH (non condensing)
Calibration: automatically at start
Length inclusive cable: 2.85m
Clamp opening: Ø12mm
Weight: 320g
