ACSRF-4030-PK, Tinytag Plus Radio Receiver Kit for Radio Data Loggers
The radio receiver is responsible for the download of all data from the wireless mesh network. It is connected to a permanently switched on computer via the USB port, and it is also powered via the USB port. From the PC, all received data are made available for the Tinytag Explorer Radio software and also for the software of third party, running on the same computer or also via the customer- owned network or via the internet.
Two alarm limits per channel (radio logger) can be programmed, that will cause warnings to be shown in the software and to make the unit's LED flash red.
E-mail warnings can be sent when alarm limits are breached, and these in turn can be used to send SMS messages using third party messaging services.
The device is equipped with backup batteries for the case that the host computer is switched off, so that the receiver's knowledge about the mesh network are maintained and the data quickly can be downloaded after the computer was switched on again.
This radio receiver pack contains the receiver, the radio logger software and a USB interface cable.
Please note: This article is only one component of the Tinytag Radio Logger System.
For proper operation minimum one radio data logger and one Tinytag radio receiver with accompanying software are necessary! Characteristics:
- radio receiver with integrated temperature monitoring
- local receiver buffer memory for the readings of 2 weeks (10min interval)
- waterproof housing, IP67
- E-mail warnings possible if alarm limits are breached
- user replaceable akaline backup battery
- power supply via the USB port
- radio licence-free frequency: 869.88 MHz (EU version)
- self-configuring and easy to set up
- low battery warning
Technical data:Radio frequency: 869.88MHz (EU Version)
Transmitting power: <5mW
Radio licence: not necessary
Integrated temperature sensor: 10k NTC thermistor
Temperature measuring range: -20°C to +55°C
Sensor response time: 10min until 90% FSK in moving air
Temperature logger resolution 0.01°C or better
Recording intervals: 2 min to 10 days
Operational temperature range: -18°C to +55°C
Housing protection: IP67, waterproof
Backup battery: 2 x Duracell Industrial ID1400 C (LR14) 1.5V (supplied)
Housing sizes: 241 x 148 x 63mm³ (h x w x d, incl. aerial)
Weight: 546g
This device is also available upon request as a version for Australia.
